The dream of owning a green laser pointer can come true

Thus, many people tried to make  green laser pointer  by themselves.  Four lenses for damage or Dirty phenomenon (the lens is damaged or too dirty. Make laser scattering) Replacement or cleaning the lens The cleaning effect is not good, The Crochet lines is very crude (3) Check the laser tube to spot quality optical port Amount of points or points of light round the empty Heart and phenomena such as the points of support for the laser tube. Direction is appropriate, the laser tube itself Adjust the bearing, rotating side To replace the laser tube Common fault repair three   Failure phenomenon.
The dream of owning a  green laser pointer  can come true. Connector card in the insulating bracket Or dry with a hairdryer damp part of the (2) high pressure fittings butt firmly, with or without Virtual company, Weld phenomenon To ensure the solder joints without virtual company, prison butt Solid (3) such as the ignition to replace the laser power inside the laser power High work Pressure ignition Laser tube high-voltage side ignition or replacement of the laser power after ignition, replace the laser tube Sweeping injustice. Check the lens and clean the lens of the optical path, adjusting Masamitsu Road.
to the outer surface of 5 debugging process, through the support points of adjustment laser or rotating laser position in order to achieve the most Good output effect, then the laser is fixed (6) Be sure to note: can not tear down the fine wire electrode, this wire is used to ensure electrode. First, buy a suitable torch to make a  green laser pointer .  Equal to the surface potential and the output window, to prevent arcing, and to avoid the inner surface of the output window Burn, to extend the life of the laser; (Note: The output window side of the glass water-cooled units excited Optical device is no such wire) .
lenses and focusing mirror frames need to remove the same The method of cleaning, as is loaded back to the cleaning is completed. Note: ① lens gently wipe, not to damage the surface coating; ② The wipe process should be gently Put, to prevent falling; ③ focusing mirror installation, be sure to keep the convex down. 4 (recommended cleaned once every two weeks, shut down operations) Rails, one of the linear axis as core components of equipment, its function is the starting orientation and support for With. High-power  green laser pointer  ( whose output power is above 150mW) are difficult to obtain.
Abnormal sound or abnormal phenomenon, the questions to be sturdy and maintenance. Machine should be a period of Time tools one by one sturdy screws. The first solid should be used in the device after a month or so. 5, the coupling of the fastening Movement in working for some time, the movement to connect the screws, the coupling will have loose, Will affect the smooth mechanical movement, so in the operation of the machine to observe the transmission parts Abnormal sound or abnormal phenomenon, the questions to be sturdy and maintenance. Using a high-power  laser pointer  to point a candle is very common.